Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Jonsered => Topic started by: Miller-Thinner2 on September 21, 2014, 11:35:18 am

Title: 2094 cuts out full throttle (fixed)
Post by: Miller-Thinner2 on September 21, 2014, 11:35:18 am

When you hold the throttle wide open the saw goes down to idle release the trigger and you can rev it back up again but when you hold it wide open it idles down again. I looked and the linkage is operating but it cuts out when full throttle  ??? Local saw shop done full service and said it was fixed but it isnt.
Any ideas on how to fix
https://www.youtube.com/watch?v=RBzTZekqn8g&feature=youtu.be

To embed videos here just click share on youtube, copy paste link here like this.
 Havent watched video yet so cant say anything. Kevin

http://youtu.be/RBzTZekqn8g


I got it fixed I had the top off and linkage works fine when not running, then i started it and reved it up,  when it cut out i seen the linkage rod move. I took it apart further and they had it put together wrong and when you rev up the saw the vibrations made the rod move out of place. 

Title: Re: 2094 cuts out full throttle (fixed)
Post by: farmboy on September 21, 2014, 09:01:03 pm

Imagine that saw shop put it together wrong.  Glad I can do my own.  Just fixed a Stihl 028 that local saw shop said was burned up not worth fixing.  Carb diaphgram & gasket in the wrong order.
Shep

Title: Re: 2094 cuts out full throttle (fixed)
Post by: weimedog on September 23, 2014, 08:50:25 pm

Sounds like that shop hopes you prefer to buy a new saw...