Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Husqvarna => Topic started by: jmester on February 28, 2016, 04:04:55 pm
-
I know this is covered here some where what are you guys using the get passed the sleeves to adjust the screws. Is there a way to eliminate them all together?
-
The sleeve is spring loaded and you just push it back out of the way.
You can take the screw out and remove the sleeve
There is a special screw driver with a sleeve on the screw driver that pushes the carb sleeve out of the way.
-
Would you happen to know what the part number is for the special screwdriver? Thanks
-
It is the splined one
-
On the end of the sleeve is a little tab you can grind off and then there is no limiter.
This is easier said than done for the sleeve is small and you put it in a vice and the sleeve will flatten. May be you could hold it with a pair of small needle nose?
-
I have a couple of different splined screwdrivers I will give them a try.
-
Had the screwdriver in stock. Didn't even think about it being splined on the outside of the screw till you said it was splined. Thank you
-
+1