Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Husqvarna => Topic started by: Brookside on April 26, 2016, 04:16:37 pm
-
I have a Husky 345. Not sure if I am getting enough oil output?
Running the saw, I do not see any oil splatter. I removed the bar and chain and
ran the saw and found oil being pumped out of the oil pump, but not sure if it's
enough oil for the chain?
I cut a lot of dead wood and find the chain has a glazed coating and is dry after
cutting for a while.
Should I replace the oil pump? Any advise on a good after market brand to use?
Can I use the adjustable oil pump that is used on the model 350?
-
Is a husky 345 the same as a jred 2145? http://chainsawrepair.createaforum.com/jonsered/cs-2145/
If it is this thread talks about upgrading the oiler to adjustable.
Might want to figure out why yours isnt oiling first. Like bar oiler hole or groove plugged up. Etc