Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Husqvarna => Topic started by: dannyupsolate on August 21, 2016, 08:44:42 pm

Title: 455 x-torq first one
Post by: dannyupsolate on August 21, 2016, 08:44:42 pm
just took in my first 455xtork .bar plate was chewed up exterior of oiler full of chips and goo. got it clean any other common problems in well used 455.
Title: Re: 455 x-torq first one
Post by: Cut4fun . on August 22, 2016, 11:00:39 am
I take care of a husqvarna 455 for a firewood cutter.   If my memory is right. Depending on when made there was a update to the bar oil tank filter. The early one was to coarse and allowed fines in to plug up line and pump. 
Also had 200T do this too.

Check the thread 455 here on it. I also had the worm gear strip and melt to the crankshaft.
Title: Re: 455 x-torq first one
Post by: dannyupsolate on August 22, 2016, 01:46:46 pm
we figured it out . beat up bar plate kept rubber part from spinning oil pump. tested it without bar plate and chain and it oiled.  bar plate pushed on top of rubber held it stationary.