Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Stihl => Topic started by: bzs on October 23, 2017, 05:31:16 pm
-
been trying to adjust the carb on ms211 went to see what the factory settings are it says on the high setting to turn screw cc till stop if I do this the screw end up in my hand ???
-
Yep the one I did dont have a stop either. Try 1.5 turns out from lightly seated. You have a tach to fine tune? If not tune by ear fat and listen to clean up in cut.
-
thank you very much how about the low side
-
thank you very much how about the low side
I dont recall where I ended up. But you will know. Start at 1 or 1.5 out and fine tune. You want no lag in throttle response. Once you have that set for quick blips you may need to adjust your I idle some. Good Luck
or just start adjust L from where it is at. Thats what I did on last one.
-
thank you very much the manual instructions are very confusing