Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Husqvarna => Topic started by: Cut4fun . on April 05, 2018, 02:25:04 pm

Title: Husqvarna 550
Post by: Cut4fun . on April 05, 2018, 02:25:04 pm
Husky 550 xp. Scoring on ext side. Barely anything on int side. Pulls over smooth. I could clean cylinder up myself IMO. But I wasnt interested in the saw for even $100 my cost myself. But I did go pick it up for a CRG member.
Dumped mix and oil and airing it out for shipping.

Title: Re: Husqvarna 550
Post by: Cut4fun on May 16, 2020, 07:42:26 am
crank bearings

OE 505133503 525434203

MKII 525434203 BALL BEARING 2 1 set  NE

 IPL's I looked at show the MkII used same both sides. 525434203 and OE one like I had used 2 different ones 505133503 525434203.

Title: Re: Husqvarna 550
Post by: 3000 FPS on May 16, 2020, 11:40:27 am
100 bucks that is not a bad deal.     If I did not have 50 running saws around here already I would have taken it too. 
Title: Re: Husqvarna 550
Post by: Cut4fun on May 19, 2020, 07:42:58 am
Husqvarna 550 cylinder made in china  OEM


They all have multiple million dollar factorys there.




Title: Re: Husqvarna 550 mkII woods port
Post by: Cut4fun on October 04, 2020, 07:37:01 am
Husqvarna 550xp mkII woods ported I got to test out yesterday running 3/8