Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Poulan => Topic started by: trail twister on December 11, 2019, 11:57:48 am
-
Looking for a bar maybe a 14" one and a chain to fit.
I am not sure what the saw took 3/8 pitch or other.
:D Al
-
What sprocket you got on it? 1/4 or 3/8LP came on the older XXV countervibe? Only seen 3/8LP on the micro ones.
Think I just pulled a 14" and chain off one in LP. But IMO be cheaper to just buy these local.
-
I have no Idea what sprocket it has I assume it is a standard factory sprocket.
:D Al
-
I have no Idea what sprocket it has I assume it is a standard factory sprocket.
:D Al
Both came on the early XXV S25DA CV series. So you need to know what you have before you get a bar chain.
Later XXV micro series was 3/8LP from what I seen.
Which series you got from these pics?
-
Same as this one.https://www.arboristsite.com/community/attachments/ed792494-d47d-446a-8bb6-0ddbeee32222-jpeg.773318/.
:D Al
-
Link shows Error :D
-
Saw says 25 CVA counter vibe on the recoil cover.
Like this.
(https://i.postimg.cc/9MCCDYtF/ED792494-D47-D-446-A-8-BB6-0-DDBEEE32222.jpg) (https://postimg.cc/QB4RP5yR)
:D Al
-
Cool. Thats the older ones. Plus side it is a AV one. 8)
Could be 1/4 or 3/8LP. Check your rim or spur sprocket to see if 9T or 6T. 9 will be 1/4 and 6 picco
Had 2 of those in CVA with AV in red and orange. Craftsamn and Wizard. Turned down to of the green AV ones as I had to many at the time.
-
Finally arrived yesterday and it has a 6 tooth sprocket.
What bar fits? then I assume it is a 3/8 pitch 50 ga. Low Profile chain so many links, I am hopeing to run a 12 or 14 inch bar.
:D Al
-
Should be a A041 mount 3/8LP 12" 45DL , 14" 62DL and 16" 56DL. I cant recall the 10" off hand.
I think I got a 14" here like new with a chain my dad was running. I went back to 12" when I got my saw back last year.
But those bar chain sets up are so cheap to buy you can get them anywhere like a walmart even.
-
Oregon Pro-91 bar, and VXL chain if it's a Super 25.