Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Jonsered => Topic started by: tadworth on April 02, 2012, 05:36:12 pm
-
Any one know if these can be tightened up, or do i need to replace parts ?
The chain is getting bogged down on quite small cuts now.
-
No adjustment. You will need a new clutch. http://s30387.gridserver.com/partsDiagrams/Jonsered%202065.pdf
-
Just wondering, what leads you to believe it is the clutches fault for bogging down in the small cuts?
Just in case it takes 3 if shoes good. http://northwoodsaw.com/store/index.php?l=product_detail&p=938
complete http://northwoodsaw.com/store/index.php?l=product_detail&p=325
-
The chain is stopped but the engine is buzzing away fine, must be the clutch ?
it's a powerfull saw, with a shorter than standard bar on it, and the chain was recently re ground.
-
Check and replace clutch drum at same time IMO. I have received them worn with big groove.
Check rim sprocket for being wore in to.
Check the clutch drum where the rim slides on.
Check the drive links on a wore out chain.
Just other things that could be causing the whole problem.