Author Topic: green weedeater  (Read 471 times)

0 Members and 62 Guests are viewing this topic.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
green weedeater
« on: March 24, 2016, 04:53:08 pm »
started with 7 of these got 6 going . all i learned is when you think carburetor is clean and they don't run right clean it again. went to 50% purple power in ultrasonic cleaner. unlike mtd brand I did not run into internal engine problems. number 7 seems to be out of time but I got to work on saws now. 100% purple power eats on the aluminum.

Share on Facebook Share on Twitter


Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: green weedeater
« Reply #1 on: March 24, 2016, 11:54:17 pm »
Even the 50% purple power will eat the aluminum if you leave it in there long enough.  I never use it for carbs.
PP 505, 475, 445.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
Re: green weedeater
« Reply #2 on: March 25, 2016, 11:29:02 am »
yes  you are correct don't leave them in it over an hour and rinse in water. put together get fuel mix in quick.  my whole idea was to speed up process . if you gonna put on shelf a while spray with wd40 or similar product, inside and outside.

 

Related Topics

  Subject / Started by Replies Last post
25 Replies
5699 Views
Last post December 20, 2011, 07:03:15 am
by Cut4fun .
3 Replies
768 Views
Last post June 29, 2012, 12:09:17 pm
by SawTroll
2 Replies
888 Views
Last post July 08, 2015, 05:02:35 pm
by Cut4fun .
7 Replies
766 Views
Last post April 16, 2014, 03:04:06 pm
by KilliansRedLeo
2 Replies
451 Views
Last post July 27, 2014, 10:47:31 am
by JohnG28
13 Replies
1766 Views
Last post December 07, 2014, 05:51:30 pm
by Cut4fun .
4 Replies
664 Views
Last post April 12, 2016, 06:30:34 pm
by dannyupsolate
0 Replies
211 Views
Last post February 26, 2018, 09:02:23 am
by Cut4fun .
0 Replies
215 Views
Last post June 15, 2020, 09:12:00 am
by Cut4fun .
4 Replies
381 Views
Last post February 11, 2021, 09:59:48 am
by muzzleblastm38