« previous next »
Pages: [1]   Go Down

Author Topic: Need Workshop Manual for Husky 42  (Read 379 times)

0 Members and 93 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

    • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Need Workshop Manual for Husky 42
« on: June 10, 2013, 10:15:16 pm »
If the bearing is in a blind pocket, you can heat the case up to about 300F in the oven and bang the parting line of the case half against a board and it will shake out.
Logged
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
986 Views 		Last post February 02, 2012, 04:46:43 pm
by Cut4fun .
1 Replies
465 Views 		Last post September 06, 2012, 07:40:56 pm
by Cut4fun .
5 Replies
683 Views 		Last post January 05, 2013, 11:35:08 pm
by 660magnum
1 Replies
357 Views 		Last post July 29, 2013, 12:26:12 pm
by Cut4fun .
1 Replies
322 Views 		Last post December 15, 2013, 01:50:16 pm
by 660magnum
2 Replies
266 Views 		Last post January 20, 2014, 12:11:50 pm
by theoldman
1 Replies
267 Views 		Last post February 25, 2014, 03:11:21 am
by 660magnum
12 Replies
862 Views 		Last post December 27, 2023, 09:12:32 am
by ray benson
1 Replies
405 Views 		Last post October 24, 2020, 12:50:06 pm
by ray benson
1 Replies
459 Views 		Last post August 23, 2021, 08:28:07 am
by ray benson