« previous next »
Pages: [1]   Go Down

Author Topic: Need Workshop Manual for Husky 42  (Read 377 times)

0 Members and 4 Guests are viewing this topic.

Offline farmboy

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1170
  • Karma: 150
  • Location: Hayesville, NC

    • Total Badges: 31
    Badges: (View All)
    Level 6 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary 1000 Posts Old Browser
Re: Need Workshop Manual for Husky 42
« on: June 11, 2013, 09:17:33 am »
Quote from: 660magnum on June 10, 2013, 10:12:53 pm
Look in your Email . . .  I sent you one there???
Thanks
Quote from: 660magnum on June 10, 2013, 10:15:16 pm
If the bearing is in a blind pocket, you can heat the case up to about 300F in the oven and bang the parting line of the case half against a board and it will shake out.
It is in a blind pocket.  This is exactly what I needed to know.  Thank you very much.
Shep
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
984 Views 		Last post February 02, 2012, 04:46:43 pm
by Cut4fun .
1 Replies
464 Views 		Last post September 06, 2012, 07:40:56 pm
by Cut4fun .
5 Replies
682 Views 		Last post January 05, 2013, 11:35:08 pm
by 660magnum
1 Replies
356 Views 		Last post July 29, 2013, 12:26:12 pm
by Cut4fun .
1 Replies
321 Views 		Last post December 15, 2013, 01:50:16 pm
by 660magnum
2 Replies
266 Views 		Last post January 20, 2014, 12:11:50 pm
by theoldman
1 Replies
267 Views 		Last post February 25, 2014, 03:11:21 am
by 660magnum
12 Replies
861 Views 		Last post December 27, 2023, 09:12:32 am
by ray benson
1 Replies
405 Views 		Last post October 24, 2020, 12:50:06 pm
by ray benson
1 Replies
459 Views 		Last post August 23, 2021, 08:28:07 am
by ray benson