Author Topic: 2054 bogging out  (Read 661 times)

0 Members and 0 Guests are viewing this topic.

Offline green-zone

  • 3 cube
  • *
  • Posts: 6
  • Karma: 0
Re: 2054 bogging out
« on: June 13, 2014, 03:46:15 pm »
The 2054 is fixed,,,, I think. Where the the vent pipe comes out of gas tank into the carb box,,,,,the vent line was off the pipe. It had been shortened and the cover screw on the right side must have hit it and it came off. While I had the cover off and the hose off I turned the saw over and gas run out of the pipe. With the saw inverted the gas would run right into the breather mounted into the top of the cover.
   I have put a new line on the vent pipe and the saw is working good. I will take it to the woods and put a couple of tanks through it. Then I will know for sure.

    Good talking with you.

 

Related Topics

  Subject / Started by Replies Last post
Jonsered 2054

Started by Cut4fun . « 1 2 » Jonsered

16 Replies
1246 Views
Last post April 21, 2013, 08:36:30 pm
by Old Iron Logging
12 Replies
636 Views
Last post September 25, 2013, 09:27:52 pm
by Vance in AK
6 Replies
463 Views
Last post October 11, 2013, 05:47:39 pm
by stihls066
10 Replies
1329 Views
Last post March 16, 2018, 05:34:35 pm
by Cut4fun .
5 Replies
412 Views
Last post November 19, 2016, 12:22:42 pm
by Cut4fun .
3 Replies
330 Views
Last post July 21, 2018, 09:30:48 am
by Toku70
0 Replies
255 Views
Last post July 21, 2018, 09:40:03 am
by Toku70