Author Topic: 2159 bogging question  (Read 585 times)

0 Members and 0 Guests are viewing this topic.

Offline mountainlake

  • 5 cube
  • ***
  • Posts: 119
  • Karma: 21
Re: 2159 bogging question
« Reply #10 on: August 31, 2013, 03:18:18 pm »

 If cutting from the top is different than cutting from the bottom check the boot between the carb and cylinder, if it has a crack on top it would open up on the up cut.   Steve

Offline Vance in AK

  • 5 cube
  • ***
  • Posts: 75
  • Karma: 1
Re: 2159 bogging question
« Reply #11 on: August 31, 2013, 03:32:56 pm »
Thanks Steve.  I will check it again.  I gave everything in there a good once over but it won't hurt to ck! Maybe it's just my imagination...  Need to play with the h/l a bit & see what that does.  Haven't touched them yet.    Just not enough hours in the day & getting ready to head out moose hunting for 9 days next Friday.

Offline Vance in AK

  • 5 cube
  • ***
  • Posts: 75
  • Karma: 1
Re: 2159 bogging question
« Reply #12 on: September 25, 2013, 09:27:52 pm »
OK, been busy moose hunting & getting the place ready for winter so haven't had much chance to play with the saw but I think I found the "bogging" problem.  When cutting from the bottom the rear grip moves away the carb (due to anti-vibe flex),moving the throttle linkage & reducing throttle opening.
I have a related question I will start a new thread on.

 

Related Topics

  Subject / Started by Replies Last post
Jonsered 2159

Started by sibur « 1 2 3 » Jonsered

20 Replies
2051 Views
Last post February 17, 2019, 02:39:46 pm
by Cut4fun .
26 Replies
1198 Views
Last post August 03, 2013, 01:37:01 pm
by Cut4fun .
5 Replies
311 Views
Last post August 08, 2013, 07:11:33 pm
by SawTroll
6 Replies
340 Views
Last post September 26, 2013, 03:16:07 pm
by sharkey
6 Replies
458 Views
Last post October 11, 2013, 05:47:39 pm
by stihls066
9 Replies
616 Views
Last post June 15, 2014, 06:07:36 pm
by green-zone
7 Replies
350 Views
Last post August 10, 2016, 06:31:22 pm
by wild262
5 Replies
225 Views
Last post November 19, 2016, 12:22:42 pm
by Cut4fun .
3 Replies
204 Views
Last post January 02, 2018, 06:01:56 am
by trail twister
3 Replies
73 Views
Last post August 17, 2020, 05:58:55 am
by Spike60