Author Topic: Jonsered 111 Dolmar 166 piston specs  (Read 191 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22030
  • Karma: 544
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Jonsered 111 Dolmar 166 piston specs
« on: December 06, 2017, 12:33:55 pm »
Here are some piston dimensions. 166 versus 111S from LeeH

Diameter 166 55.88 111S 55.89
Pin Diameter both 14mm
total height 166 49.50 111S 50.08
top of pin bore
to crown 166 17.50 111S 16.62 not counting crown
The 166 is a flat top, 111S is a domed piston
Put the pin through both pistons and the 166 is close to the top off
the 111S piston but the edge of the 166 is taller than the 111S so
it would make more compression providing there is room in the squish
band on the cylinder or have it machined.
I would say the 166 piston in a 111S would make more power.

REDNECK Saw Repair Getter Done

Share on Facebook Share on Twitter


Offline mdavlee .

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171
Re: Jonsered 111 Dolmar 166 piston specs
« Reply #1 on: December 07, 2017, 09:51:30 am »
Interesting. 166 with squish set in 111 would be best.

 

Related Topics

  Subject / Started by Replies Last post
72 Replies
6980 Views
Last post August 30, 2015, 01:21:23 pm
by Cut4fun .
2 Replies
1179 Views
Last post December 10, 2011, 10:38:37 pm
by 660magnum
0 Replies
399 Views
Last post October 25, 2011, 06:14:43 pm
by mdavlee
17 Replies
3516 Views
Last post August 26, 2015, 03:10:42 pm
by Cut4fun .
8 Replies
353 Views
Last post March 17, 2014, 09:07:10 am
by fordfairlane78
2 Replies
369 Views
Last post June 19, 2014, 03:32:20 pm
by farmboy
6 Replies
143 Views
Last post June 14, 2014, 02:48:05 pm
by KilliansRedLeo
3 Replies
218 Views
Last post October 18, 2014, 10:06:51 pm
by Al Smith
12 Replies
472 Views
Last post January 24, 2016, 09:46:36 am
by Cut4fun .
1 Replies
122 Views
Last post June 17, 2016, 04:52:19 pm
by 1manband