Author Topic: Husqared 3171  (Read 1040 times)

0 Members and 8 Guests are viewing this topic.

Offline Chris_Elliott

  • 3 cube
  • *
  • Posts: 12
  • Karma: 2

  • Total Badges: 14
    Badges: (View All)
    10 Posts Combination Level 3 Karma Karma Good Topic Starter
Re: Husqared 3171
« on: December 19, 2014, 03:54:54 pm »
So I had a Husqvarna handlebar, and the Jonsered fuel tank. They don't work together, right? The angle and mounts are different.
Well each of those parts was good, and I wasn't about to buy any new parts, so I MADE it work. Total redneck repair  ;D

Bottom mounts up just fine




The side mounts is what presents the problem. The Jonsered handlebar is angled at the bottom, and the holes are in different locations. The bottom hole matched up, and I just drilled a hole for the top tank mount and the cylinder AV mount. The handlebar might be a little bit wonky, but I've seen handlebars bent ALOT worse and still ran on saws.