Author Topic: Jonsered 111 (Read 2387 times)

mdavlee . · « **Reply #20 on:** August 28, 2014, 02:04:08 pm »

You may have to measure the circumference of the flywheel and divide by 360 to get the 3.8mm in degrees.

Peter Davies · « **Reply #21 on:** August 29, 2014, 08:07:17 am »

That's the problem; there are several "perimeters" where one could measure the distance!

mdavlee . · « **Reply #22 on:** August 29, 2014, 10:28:06 am »

Just pick one and go with it

Peter Davies · « **Reply #23 on:** August 30, 2014, 11:17:45 am »

attached is photo of fly wheel. I think the right hand mark is TDC; what are the other two? They are much further than 3.8mm. Do you measure 3.8 at the perimeter, or on the circumference where these marks lie?

mdavlee . · « **Reply #24 on:** August 30, 2014, 02:37:20 pm »

I would measure all the way around and see where that puts you. It's hard to say how they set it up.

660magnum · « **Reply #25 on:** August 30, 2014, 10:16:02 pm »

Quote from: Peter Davies on August 30, 2014, 11:17:45 am

attached is photo of fly wheel. I think the right hand mark is TDC; what are the other two? They are much further than 3.8mm. Do you measure 3.8 at the perimeter, or on the circumference where these marks lie?

Those holes are where the balanced the flywheel

Chainsaw Repair

News:

Author Topic: Jonsered 111 (Read 2387 times)

mdavlee .

Re: Jonsered 111

Peter Davies

Re: Jonsered 111

mdavlee .

Re: Jonsered 111

Peter Davies

Re: Jonsered 111

mdavlee .

Re: Jonsered 111

660magnum

Re: Jonsered 111

Related Topics