Author Topic: Jonsered 2077 & 2083 ignition  (Read 791 times)

0 Members and 0 Guests are viewing this topic.

Offline Spike60

  • Piped Saw
  • *****
  • Posts: 320
  • Karma: 101
  • Location: Ulster County, NY
Re: Jonsered 2077 & 2083 ignition
« on: October 18, 2013, 04:41:45 pm »
We're lucky that they interchange to that degree, cause it makes completing project saws so much easier. very much the same for the newer generation of saws as well. This morning I put a 455 rancher coil in a 372. Wire is a little on the short side, but it should be fine.

Not sure that this info is correct as I looked one up last night. The Husqvarna EPC says that the coils for these saws are unique to the chassis. The Partner coils may indeed work, as this is a Partner design. But I have doubts that the 51/55 coil will work in this chassis. Did anyone try this yet to see if it fits?
Husqvarna-Jonsered

Ashokan Turf and Timber

845-657-6395

 

Related Topics

  Subject / Started by Replies Last post
27 Replies
806 Views
Last post February 22, 2017, 07:26:04 pm
by Cut4fun .
5 Replies
315 Views
Last post August 24, 2014, 10:40:36 am
by Cut4fun
38 Replies
858 Views
Last post June 21, 2016, 01:32:54 pm
by Cut4fun .
4 Replies
240 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
1 Replies
448 Views
Last post January 14, 2017, 02:17:56 pm
by Cut4fun .
1 Replies
179 Views
Last post May 24, 2018, 09:28:10 pm
by Cut4fun .
6 Replies
185 Views
Last post July 22, 2017, 12:54:36 pm
by 3000 FPS
18 Replies
442 Views
Last post December 22, 2019, 09:51:20 am
by Cut4fun .
15 Replies
288 Views
Last post November 16, 2018, 02:56:14 pm
by Cut4fun .
3 Replies
108 Views
Last post October 23, 2018, 11:16:06 am
by Cut4fun .