Author Topic: Jonsered 2083  (Read 8524 times)

0 Members and 1 Guest are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4038
  • Karma: 159
  • OHIO REDNECK
Re: Jonsered 2083
« Reply #50 on: April 11, 2013, 06:06:46 pm »
066 Meteor piston is .020 higher then 2083 OEM piston. Squish with gasket, OEM piston was .041. With 066 piston squish is at .021. Comp is at 170 pounds. The 2083 rod is wider than the 066, piston needs to be opened up. Runs good ;).

Ron I paid closer attention to my measurements this time and measured the squish closer to where the piston and cylinder  intersect.   I came up with .0245 at tightest on the afm 066 piston with used gasket.

The oem 505 one on the other saw when I installed today was .040 with new oem gasket.  I checked the 425 top before puling it and it was .0435 with used gasket.
REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
321 Views
Last post August 24, 2014, 10:40:36 am
by Cut4fun
35 Replies
1368 Views
Last post January 12, 2016, 11:32:53 am
by Tractorsaw1
38 Replies
868 Views
Last post June 21, 2016, 01:32:54 pm
by Cut4fun .
4 Replies
265 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
1 Replies
469 Views
Last post January 14, 2017, 02:17:56 pm
by Cut4fun .
1 Replies
183 Views
Last post May 24, 2018, 09:28:10 pm
by Cut4fun .
6 Replies
186 Views
Last post July 22, 2017, 12:54:36 pm
by 3000 FPS
18 Replies
449 Views
Last post December 22, 2019, 09:51:20 am
by Cut4fun .
15 Replies
313 Views
Last post November 16, 2018, 02:56:14 pm
by Cut4fun .
3 Replies
110 Views
Last post October 23, 2018, 11:16:06 am
by Cut4fun .