Chainsaw Repair

Now I'm curious... I haven't run my 2094 in a few years. Last I did I seem to remember it ran under load a bit higher RPM than that one did. Twisted like a 372. Wound it up to 13,500 No load. All it had was squish set to .018, a muffler mod (Gutted with a 3/4 in tube), and a little more duration on the intake. That may have been the one I struggled with because of a limited carb & eventually swapped it out...or was that the first 820. Can't remember anymore. I quit running it as it was a biatch to pull over and start & felt like the pull start was one step away from coming apart. Hardly a modded saw but it was really strong. BUT time tempers reality. So it needs to get some video/timing and compare it to those Aftermarket MS660 saws. Also hardly modified saws but a reasonable reference. Doubt there will be a 3 to 2 cut differential in a test log of hard maple. Just curious. Would be curious on how fast the 2094 picks up RPM's.. Mine was lively like a crisp 372, just bigger and more of everything. (Including vibration and weight)

This might simply be a verification the one building that 660 know his chit.. That's my bet.