Author Topic: Jonsered 801  (Read 1410 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Jonsered 801
« Reply #10 on: October 25, 2016, 02:48:07 pm »
You can use D096/D196/UXL and D007 mount bars on these saws.  Usually have to open up the slot with a file a tad, as these bars are 9.5mm (.375") while the original D024 mount bars are 10mm (.400").  Those old JReds are strong.  I've ran a 111S and it was a brute. 
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
Jonsered 490

Started by bloodontheice « 1 2 3 4 5 » Jonsered

44 Replies
6198 Views
Last post April 22, 2020, 12:26:59 pm
by Cut4fun .
Jonsered 590

Started by Cut4fun « 1 2 ... 5 6 » Jonsered

58 Replies
4986 Views
Last post January 25, 2019, 03:05:09 pm
by Cut4fun .
Jonsered 2159

Started by sibur « 1 2 3 » Jonsered

20 Replies
1990 Views
Last post February 17, 2019, 02:39:46 pm
by Cut4fun .
15 Replies
788 Views
Last post September 09, 2014, 10:01:46 pm
by mdavlee .
Jonsered 525

Started by joker « 1 2 » Jonsered

10 Replies
1063 Views
Last post January 03, 2016, 02:42:43 pm
by leec
4 Replies
262 Views
Last post December 22, 2014, 06:14:48 pm
by Cut4fun .
0 Replies
191 Views
Last post October 10, 2015, 02:12:24 pm
by Cut4fun .
1 Replies
320 Views
Last post October 13, 2015, 12:24:47 pm
by Cut4fun
7 Replies
583 Views
Last post November 24, 2016, 10:29:54 pm
by RoyM
3 Replies
280 Views
Last post March 27, 2019, 07:32:39 pm
by Cut4fun .