« previous next »
Pages: 1 2 3 [4] 5   Go Down

Author Topic: Jonsered 801  (Read 4579 times)

0 Members and 57 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Jonsered 801
« Reply #30 on: November 26, 2016, 07:00:37 pm »
Replaced the other crank seal today.    I had already done the other side.    I cleaned the points while I had it apart and moved the plate the points mount to about 1/16 of an inch to give it a little more advance on the timing.   The saw starts and runs great.    The other thing to my surprise is a Mahle cylinder.   Nice.

Logged
PP 505, 475, 445.
Pages: 1 2 3 [4] 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
Jonsered 670 630 625

Started by Cut4fun . « 1 2 ... 12 13 » Jonsered

121 Replies
7024 Views 		Last post April 01, 2024, 09:02:34 am
by Cut4fun .
Jonsered 2159

Started by sibur « 1 2 3 4 » Jonsered

30 Replies
4800 Views 		Last post December 28, 2021, 09:27:03 am
by Cut4fun .
jonsered 52e

Started by man of stihl « 1 2 » Jonsered

15 Replies
1727 Views 		Last post December 09, 2013, 08:19:17 pm
by Spike60
15 Replies
1803 Views 		Last post September 09, 2014, 10:01:46 pm
by mdavlee .
Jonsered 525

Started by joker « 1 2 » Jonsered

10 Replies
2098 Views 		Last post January 03, 2016, 02:42:43 pm
by leec
4 Replies
843 Views 		Last post December 22, 2014, 06:14:48 pm
by Cut4fun .
7 Replies
666 Views 		Last post January 20, 2015, 08:46:22 pm
by man of stihl
0 Replies
415 Views 		Last post October 10, 2015, 02:12:24 pm
by Cut4fun .
1 Replies
677 Views 		Last post October 13, 2015, 12:24:47 pm
by Cut4fun
7 Replies
1361 Views 		Last post November 24, 2016, 10:29:54 pm
by RoyM