Author Topic: Jonsered 2159  (Read 4772 times)

0 Members and 47 Guests are viewing this topic.

Offline sibur

  • 3 cube
  • *
  • Posts: 6
  • Karma: 1

  • Total Badges: 6
    Badges: (View All)
    Level 2 Second year Anniversary One year Anniversary Topic Starter Level 1 First Post
Re: Jonsered CS2159C toast
« on: June 13, 2012, 04:59:09 pm »
Thanks, I'm not really sure what caused the saw to burn up, the gas/oil mixture was fresh. The dealer said ethanol in the gas could have caused the problem. I did not use ethanol treatment in the gas. Do you think this may have caused the saw to run hot and gaul the piston/ring? The saw ran about 10 to 15 minutes before it quit. I will inspect the cylinder and see if it looks salvageable. Any other suggestions? I've been reading that the Meteror Pistons are a good aftermarket brand.

 

Related Topics

  Subject / Started by Replies Last post
Jonsered 490

Started by bloodontheice « 1 2 3 4 5 » Jonsered

45 Replies
9941 Views
Last post March 08, 2022, 09:52:52 am
by Cut4fun .
Jonsered 590

Started by Cut4fun « 1 2 ... 5 6 » Jonsered

58 Replies
8404 Views
Last post January 25, 2019, 03:05:09 pm
by Cut4fun .
Jonsered 535

Started by farmboy « 1 2 » Jonsered

19 Replies
4648 Views
Last post April 30, 2018, 01:42:23 pm
by leec
26 Replies
3788 Views
Last post August 03, 2013, 01:37:01 pm
by Cut4fun .
5 Replies
595 Views
Last post August 08, 2013, 07:11:33 pm
by SawTroll
12 Replies
1313 Views
Last post September 25, 2013, 09:27:52 pm
by Vance in AK
6 Replies
735 Views
Last post September 26, 2013, 03:16:07 pm
by sharkey
7 Replies
853 Views
Last post August 10, 2016, 06:31:22 pm
by wild262
3 Replies
644 Views
Last post January 02, 2018, 06:01:56 am
by trail twister
3 Replies
247 Views
Last post March 07, 2022, 01:50:03 pm
by Cut4fun .