Chainsaw Repair

Quote from: Cut4fun2 on September 10, 2012, 10:54:47 pm

I forgot about  555 .   whats the difference in 555 and 562 carbs?

I can't remember for sure if it was the micro or coil that was different.  The original coils were the same (99% sure of that) 

Quote from: Mastermind on September 10, 2012, 10:59:33 pm

Good question....

Mitch Weber had an extra so......

I've been testing one of the carbs William sent me and its holding strong.  Brad will be getting that one for the long term.   The other one sent to me is giving me trouble so you will be getting a 555 carb pulled from a squished saw.  I do need your addy though as I can't find that box.

A side note, I've had no trouble boring these carbs.  Ed has said he bores them as well. 

The only issue I see with boring the carb is changing fuel delivery. The low pressure signal would be weaker if the venturi was enlarged......I think it may cause the engine to go leaner rather than adding more fuel.

I think they are getting plenty of air flow through the strato ports so why would the carb need to be bored?