Author Topic: West Coast Jonsered 2077  (Read 1380 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2108
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: West Coast Jonsered 2077
« on: February 22, 2015, 04:19:55 pm »
That setup looks like it was taken from a demo saw.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
9 Replies
627 Views
Last post May 03, 2013, 01:44:44 pm
by HMLT360Pro
12 Replies
791 Views
Last post December 06, 2013, 02:16:11 pm
by David Young
4 Replies
345 Views
Last post November 16, 2018, 11:50:33 am
by Cut4fun .
5 Replies
315 Views
Last post August 24, 2014, 10:40:36 am
by Cut4fun
3 Replies
339 Views
Last post August 21, 2015, 12:53:25 pm
by Cut4fun .
38 Replies
856 Views
Last post June 21, 2016, 01:32:54 pm
by Cut4fun .
4 Replies
240 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
1 Replies
448 Views
Last post January 14, 2017, 02:17:56 pm
by Cut4fun .
10 Replies
619 Views
Last post December 17, 2016, 05:22:18 am
by Eccentric
1 Replies
179 Views
Last post May 24, 2018, 09:28:10 pm
by Cut4fun .