Author Topic: Jonsered 801  (Read 1025 times)

0 Members and 0 Guests are viewing this topic.

Offline Cjohnston77

  • pruner
  • *
  • Posts: 1
  • Karma: 0
Re: Jonsered 801
« Reply #40 on: November 28, 2018, 02:51:03 pm »
Does anyone know the base carb settings for the 801

Online ray benson

  • 5 cube
  • ***
  • Posts: 105
  • Karma: 49
  • Retired Industrial Electrician
  • Location: Indiana
Re: Jonsered 801
« Reply #41 on: November 28, 2018, 03:20:13 pm »
Out of a Clymer service manual
Tillotson diaphragm carburetor.
Initial carburetor adjustment is one
turn open from a lightly seated position
for both low and high speed mixture
screws. Make final adjustment with
engine warm and running. Adjust idle
speed screw so engine idles just below
speed mixture screw so engine will accelerate
cleanly without hesitation. Adjust
high speed mixture screw to obtain
optimum performance under cutting
load.

Like Like x 2 View List

Offline HolmenTree

  • Nitro Hotsaw
  • *******
  • Posts: 1275
  • Karma: 162
  • Location: Manitoba Canada
Re: Jonsered 801
« Reply #42 on: November 29, 2018, 07:10:18 am »
Does anyone know the base carb settings for the 801
From my 1970's memory running those Tilly HS Jonsereds "base" setting that they ran  best at was 1 1/4 turn out L and 3/4 turn out H
Making a living with a saw since age 16.

 

Related Topics

  Subject / Started by Replies Last post
Jonsered 490

Started by bloodontheice « 1 2 3 4 5 » Jonsered

41 Replies
5667 Views
Last post March 26, 2019, 06:33:27 am
by Cut4fun .
Jonsered 590

Started by Cut4fun « 1 2 ... 5 6 » Jonsered

58 Replies
4557 Views
Last post January 25, 2019, 03:05:09 pm
by Cut4fun .
Jonsered 2159

Started by sibur « 1 2 3 » Jonsered

20 Replies
1756 Views
Last post February 17, 2019, 02:39:46 pm
by Cut4fun .
15 Replies
726 Views
Last post September 09, 2014, 10:01:46 pm
by mdavlee .
Jonsered 525

Started by joker « 1 2 » Jonsered

10 Replies
992 Views
Last post January 03, 2016, 02:42:43 pm
by leec
4 Replies
216 Views
Last post December 22, 2014, 06:14:48 pm
by Cut4fun .
0 Replies
164 Views
Last post October 10, 2015, 02:12:24 pm
by Cut4fun .
1 Replies
290 Views
Last post October 13, 2015, 12:24:47 pm
by Cut4fun
7 Replies
481 Views
Last post November 24, 2016, 10:29:54 pm
by RoyM
3 Replies
100 Views
Last post March 27, 2019, 07:32:39 pm
by Cut4fun .