Author Topic: 3/4 factory wrap handle bars.  (Read 898 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: 3/4 factory wrap handle bars.
« Reply #10 on: November 28, 2013, 06:50:40 pm »
i'm interested in the 660 wrap if it is still available.

Hiya TS.  I see you found your way over here alright.:D
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
384 Views
Last post May 09, 2011, 08:34:12 am
by 05_sprcrw
9 Replies
1487 Views
Last post December 04, 2013, 02:58:16 pm
by Eccentric
1 Replies
365 Views
Last post August 18, 2011, 12:17:26 am
by Roanoker494
2 Replies
197 Views
Last post February 19, 2013, 08:07:04 pm
by riverrocket
1 Replies
190 Views
Last post October 19, 2013, 11:59:12 pm
by stihls066
28 Replies
908 Views
Last post June 02, 2014, 10:27:54 am
by KilliansRedLeo
6 Replies
149 Views
Last post August 21, 2017, 08:12:55 am
by deezlfan
2 Replies
112 Views
Last post August 19, 2017, 11:55:21 am
by deezlfan
2 Replies
182 Views
Last post May 17, 2019, 02:27:51 am
by Hoggwood
3 Replies
5 Views
Last post March 09, 2019, 07:11:53 pm
by Cut4fun .