Author Topic: Top end for Poulan 3000  (Read 204 times)

0 Members and 0 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Top end for Poulan 3000
« on: April 11, 2014, 05:09:26 pm »
I have a nice runner but would like to mess with it a bit. I am looking for a top end from a larger version to try to give it a little extra poop.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22571
  • Karma: 591
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Top end for Poulan 3000
« Reply #1 on: April 11, 2014, 10:55:57 pm »
You would want a plated bore 335 54cc then with a harder to find thin ring piston.  To make it easier just use a 3450 piston with thick ring.
Thin rings NLA for 335.

Could go bare bore 3300 with plated piston for 54cc too

Both bolt ons.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
460 Views
Last post December 11, 2012, 04:27:45 pm
by Cut4fun .
44 Replies
1952 Views
Last post July 26, 2015, 05:45:30 pm
by Cut4fun .
3 Replies
450 Views
Last post February 03, 2013, 06:33:10 pm
by 660magnum
2 Replies
164 Views
Last post September 13, 2013, 02:57:45 pm
by KilliansRedLeo
18 Replies
460 Views
Last post January 25, 2014, 08:03:36 am
by The Ripper
16 Replies
790 Views
Last post April 15, 2014, 08:29:22 pm
by Tractorsaw1
3 Replies
197 Views
Last post November 08, 2014, 08:11:47 pm
by Cut4fun .
Poulan 3000

Started by Drew_Uth « 1 2 ... 6 7 » Poulan

63 Replies
1243 Views
Last post September 11, 2020, 02:40:03 pm
by Cut4fun
1 Replies
44 Views
Last post September 18, 2020, 02:36:28 pm
by Cut4fun .
0 Replies
22 Views
Last post February 13, 2021, 08:08:23 am
by Cut4fun