Author Topic: McCulloch 10-10 x2  (Read 441 times)

0 Members and 0 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181
Re: McCulloch 10-10 x2
« on: December 24, 2011, 07:48:37 pm »
They can be tweeked a tad if you want .By it's very design the 10 series are pullers but that aren't revers  unless you fiddle with them .

The porting is  very different using a triple groove semi open type with staggered transfer design .Some of the larger displacement ten series only used two grooves . The weak link is the bottom exit exhaust which causes the same effect as pushing air down a heating duct with a square corner .It about like hitting a brick wall .

Some designs of the ten series engines used a muffler with a round transition which gives the best performance .I'm thinking it might have been on one of he earlier 10-10 with right hand start .

Really though aside from perhaps some work on the ex port and maybe bumping the timing a tad there isn't really much you can do with them .A little bigger carb perhaps depending on what's already on it .

Now try as I may for years I've only came close to getting a Mac 10 series out cut a Stihl .I've gotten close but haven't got er done yet .--I'm not done though ,never say die . ;)

 

Related Topics

  Subject / Started by Replies Last post
24 Replies
2124 Views
Last post June 01, 2013, 12:24:49 pm
by HMLT360Pro
4 Replies
868 Views
Last post October 09, 2011, 01:23:47 pm
by Al Smith
32 Replies
4957 Views
Last post October 05, 2021, 09:59:13 am
by joe_indi
21 Replies
3463 Views
Last post March 12, 2016, 05:14:26 am
by Al Smith
3 Replies
743 Views
Last post May 09, 2012, 04:59:28 pm
by 660magnum
2 Replies
1477 Views
Last post May 14, 2012, 07:16:18 pm
by Al Smith
25 Replies
4470 Views
Last post July 05, 2015, 08:11:30 pm
by Al Smith
1 Replies
759 Views
Last post October 05, 2012, 12:40:53 pm
by Cut4fun .
1 Replies
306 Views
Last post November 07, 2012, 10:27:43 pm
by Roanoker494
1 Replies
481 Views
Last post December 14, 2012, 03:48:10 pm
by oldpart