Author Topic: Confused about Pro Mac 10-10S fuel line part #  (Read 1578 times)

0 Members and 1 Guest are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Confused about Pro Mac 10-10S fuel line part #
« on: April 11, 2014, 07:59:24 pm »
Does your fuel tank have an aluminum bushing pressed/glued into the tank divider (that the line passes through)?  If so, your saw likely has had the 'conversion kit' installed on it some time in the past.  The kit consisted of that bushing, some glue/sealant, a length of line, a fuel filter, and another carburetor (with the smaller inlet barb to match the line).  Just replace the line with a fresh piece of matching size (IIRC it is 1/8" ID 3/16" OD).   Would you please post a pic or two of the carb box area in your saw to show the bushing for those folks here that haven't seen one?
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
18 Replies
4369 Views
Last post March 26, 2017, 05:46:32 pm
by Cut4fun .
2 Replies
432 Views
Last post March 28, 2012, 12:27:35 pm
by nmurph
11 Replies
895 Views
Last post October 30, 2016, 09:16:26 am
by Sty57
6 Replies
639 Views
Last post January 11, 2013, 05:01:34 pm
by Cut4fun .
9 Replies
311 Views
Last post November 17, 2017, 08:22:36 am
by Cut4fun .
2 Replies
390 Views
Last post August 26, 2013, 01:39:22 pm
by Bluegill
38 Replies
733 Views
Last post November 30, 2015, 03:40:50 pm
by dynodave
15 Replies
1841 Views
Last post April 30, 2014, 11:58:07 pm
by Eccentric
3 Replies
326 Views
Last post July 20, 2014, 06:32:40 pm
by 660magnum
2 Replies
430 Views
Last post August 05, 2014, 11:05:08 pm
by farmboy