Author Topic: Confused about Pro Mac 10-10S fuel line part #  (Read 1578 times)

0 Members and 1 Guest are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Confused about Pro Mac 10-10S fuel line part #
« on: April 16, 2014, 01:10:01 pm »
That looks like 3/16x5/16" line...............that is a sloppy fit in the hole.  No wonder it's leaking.  Take the line out and measure the hole.  If it's around 10mm/.4", then the hole takes the standard molded line.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
18 Replies
4369 Views
Last post March 26, 2017, 05:46:32 pm
by Cut4fun .
2 Replies
432 Views
Last post March 28, 2012, 12:27:35 pm
by nmurph
11 Replies
895 Views
Last post October 30, 2016, 09:16:26 am
by Sty57
6 Replies
639 Views
Last post January 11, 2013, 05:01:34 pm
by Cut4fun .
9 Replies
311 Views
Last post November 17, 2017, 08:22:36 am
by Cut4fun .
2 Replies
390 Views
Last post August 26, 2013, 01:39:22 pm
by Bluegill
38 Replies
733 Views
Last post November 30, 2015, 03:40:50 pm
by dynodave
15 Replies
1841 Views
Last post April 30, 2014, 11:58:07 pm
by Eccentric
3 Replies
326 Views
Last post July 20, 2014, 06:32:40 pm
by 660magnum
2 Replies
430 Views
Last post August 05, 2014, 11:05:08 pm
by farmboy