« previous next »
Pages: [1]   Go Down

Author Topic: Confused about Pro Mac 10-10S fuel line part #  (Read 1577 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Confused about Pro Mac 10-10S fuel line part #
« on: April 16, 2014, 01:15:08 pm »



These are the two styles of molded lines.  You'll notice that the 'grommet' section in the middle is only slightly larger in diameter than the OD of the end that fits over the carb inlet barb.
Logged
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
18 Replies
4369 Views 		Last post March 26, 2017, 05:46:32 pm
by Cut4fun .
2 Replies
431 Views 		Last post March 28, 2012, 12:27:35 pm
by nmurph
11 Replies
895 Views 		Last post October 30, 2016, 09:16:26 am
by Sty57
6 Replies
639 Views 		Last post January 11, 2013, 05:01:34 pm
by Cut4fun .
9 Replies
311 Views 		Last post November 17, 2017, 08:22:36 am
by Cut4fun .
2 Replies
390 Views 		Last post August 26, 2013, 01:39:22 pm
by Bluegill
38 Replies
733 Views 		Last post November 30, 2015, 03:40:50 pm
by dynodave
15 Replies
1836 Views 		Last post April 30, 2014, 11:58:07 pm
by Eccentric
3 Replies
326 Views 		Last post July 20, 2014, 06:32:40 pm
by 660magnum
2 Replies
430 Views 		Last post August 05, 2014, 11:05:08 pm
by farmboy