« previous next »
Pages: [1]   Go Down

Author Topic: Gear drive 10 10 Mac  (Read 714 times)

0 Members and 18 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2117
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northwestern Wyoming

    • Total Badges: 37
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary
Re: Gear drive 10 10 Mac
« on: September 13, 2015, 04:05:33 pm »
That saw is likely a G70.  There were a number of 54-70cc 10-series gear drives.

I have a 5-10G plus a parts saw and a partial carcass.  Will build a nice runner out of the lot at some point.  There are many saws ahead of it in the project line.  IIRC, it had a 32" or so bar and a loop of 1/2" on it when I got it.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
1 Replies
501 Views 		Last post April 14, 2011, 09:41:02 pm
by man of stihl
6 Replies
1123 Views 		Last post February 07, 2018, 10:07:18 am
by Cut4fun .
22 Replies
862 Views 		Last post January 20, 2014, 06:22:37 pm
by Tractorsaw1
0 Replies
143 Views 		Last post January 01, 2014, 02:29:34 am
by stihls066
6 Replies
411 Views 		Last post February 24, 2014, 10:30:11 am
by srcarr52
0 Replies
279 Views 		Last post February 17, 2016, 06:38:53 pm
by scwoody
5 Replies
692 Views 		Last post November 15, 2017, 08:02:45 am
by Cut4fun
0 Replies
425 Views 		Last post June 15, 2016, 08:20:51 pm
by Cut4fun .
0 Replies
334 Views 		Last post January 06, 2017, 09:20:24 pm
by aclarke
4 Replies
344 Views 		Last post December 15, 2017, 06:21:55 am
by Al Smith