Author Topic: mc-ms1435, 2 problems solved  (Read 162 times)

0 Members and 0 Guests are viewing this topic.

Offline jrdplowing

  • 4 cube
  • **
  • Posts: 26
  • Karma: 1
mc-ms1435, 2 problems solved
« on: November 07, 2015, 04:16:36 pm »
well i inspected the tensioner again and can see it is worn,slightly bent,and threads show wear,so it needed to be slowly put together and tension properly,but leave the bar down, do not raise for final tightening,and tighten slowly and evenly, and not overtighten,then with the carb there is a 3 piece limit cap,the first one comes off and you do not need,then the remaining caps in the H-L settings can be pulled slightly back and then back turned,then pushed back,  to increase adjustability, and now is cutting thru huge wet popple with no problem,hope this helps for someone in the future,thanks 

Share on Facebook Share on Twitter


 

Related Topics

  Subject / Started by Replies Last post
5 Replies
621 Views
Last post January 02, 2013, 08:23:58 am
by William Greene
5 Replies
221 Views
Last post January 27, 2013, 11:42:57 am
by Al Smith
4 Replies
306 Views
Last post March 22, 2013, 10:13:50 pm
by 660magnum
6 Replies
1241 Views
Last post June 02, 2013, 09:30:02 pm
by brokenbudget
27 Replies
393 Views
Last post March 23, 2014, 04:52:19 am
by dutchsawdoctor
7 Replies
538 Views
Last post February 21, 2014, 07:37:00 am
by Sawnami
1 Replies
342 Views
Last post June 11, 2015, 10:26:13 pm
by Al Smith
9 Replies
185 Views
Last post February 22, 2017, 10:41:26 pm
by RoyM
3 Replies
184 Views
Last post July 08, 2017, 02:51:01 am
by snoozeys
3 Replies
309 Views
Last post September 06, 2020, 07:58:46 am
by Spike60