Author Topic: mcc 1435 was running, now wont start  (Read 192 times)

0 Members and 0 Guests are viewing this topic.

Offline jrdplowing

  • 4 cube
  • **
  • Posts: 26
  • Karma: 1
mcc 1435 was running, now wont start
« on: September 12, 2015, 08:35:31 pm »
has spark, and has 75lbs comp with 1 full pull, missing primer bulb but was running fine until i filled the tank with gas, and new spark plug .030 gap. also wet air filter with gas directly and wont even pop,tried with and without choke,any help would be appreciated       

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21944
  • Karma: 531
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: mcc 1435 was running, now wont start
« Reply #1 on: September 12, 2015, 09:18:11 pm »
Try .020 and pull plug pull over and let set 24 hours to air dry from guessing flooding.  Also check for spark and make sure turned to on. Yes it happens even to me.

Need more then 75lbs so keep pulling till psi stops going up and then look. 
REDNECK Saw Repair Getter Done

Offline jrdplowing

  • 4 cube
  • **
  • Posts: 26
  • Karma: 1
Re: mcc 1435 was running, now wont start
« Reply #2 on: September 12, 2015, 09:44:05 pm »
yes sounds good, i will try and get back on a repost,probably by monday, thanks

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
626 Views
Last post January 05, 2012, 08:44:51 am
by Al Smith
4 Replies
1159 Views
Last post February 21, 2012, 09:43:13 am
by mweba
80 Replies
2520 Views
Last post February 13, 2014, 02:37:33 pm
by mastercraftka
MS360 Pro wont start

Started by ears54 « 1 2 » Stihl

10 Replies
488 Views
Last post August 16, 2015, 03:37:13 pm
by Cut4fun .
36 Replies
1513 Views
Last post February 11, 2016, 11:17:11 am
by 3000 FPS
2 Replies
376 Views
Last post December 30, 2015, 03:58:15 pm
by Cat-Face Timber
1 Replies
463 Views
Last post March 17, 2016, 07:47:57 pm
by Cut4fun .
4 Replies
724 Views
Last post November 27, 2016, 08:59:14 pm
by mdavlee .
1 Replies
197 Views
Last post May 24, 2017, 01:41:04 pm
by Cut4fun .
11 Replies
1791 Views
Last post June 05, 2017, 02:48:32 pm
by 3000 FPS