Author Topic: McCulloch oil pump problem  (Read 10847 times)

0 Members and 44 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

  • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: McCulloch oil pump problem
« Reply #40 on: June 16, 2013, 11:22:50 am »
There is a very fine line on the points type 10 series saws .If you get just the right amount of advance they run like a scalded ape .Too much they try to break your wrist .

They don't have a very large starter drum .The little ones like the 10-10 aren't bad but 70 cc and larger just the compression alone can hurt you .

On the oilers though I've had some leakers none really were that bad on this style of pump .Now the diaphragm type impulse pumps on the later PM 610-650 will cause lots of problems .Those will hyraulically lock up a cylinder to the point you can't pull them over . You have to blow the oil out to even get them to roll over .

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1815 Views
Last post July 15, 2012, 07:13:26 am
by farmboy
4 Replies
1356 Views
Last post April 02, 2012, 09:31:29 am
by 2spud
2 Replies
574 Views
Last post July 19, 2012, 08:02:44 pm
by Cut4fun .
5 Replies
648 Views
Last post December 03, 2012, 02:16:45 pm
by Cut4fun
7 Replies
1187 Views
Last post October 15, 2013, 08:14:57 pm
by jmester
7 Replies
671 Views
Last post November 22, 2013, 02:02:14 pm
by Cut4fun .
6 Replies
753 Views
Last post November 10, 2013, 07:13:26 am
by rayvil01
394 oil pump ?

Started by alsled « 1 2 » Husqvarna

15 Replies
1021 Views
Last post November 23, 2013, 07:43:04 pm
by alsled
14 Replies
1495 Views
Last post December 18, 2017, 06:48:12 pm
by Cut4fun .
3 Replies
561 Views
Last post June 04, 2016, 04:09:27 am
by Le Maisonniau