« previous next »
Pages: [1]   Go Down

Author Topic: Mcculloch SP81  (Read 391 times)

0 Members and 0 Guests are viewing this topic.

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Mcculloch SP81
« on: February 28, 2016, 10:37:02 pm »
I recently acquired an sp81. I'm wondering why there is only one mixture adjustment screw on the carb. I'm assuming it's for high speed adjustments and there is no adjustment for low speed mixture ?
Logged

Share on Facebook Share on Twitter

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Re: Mcculloch SP81
« Reply #1 on: February 29, 2016, 10:50:37 am »
here's a picture of the carb
Logged

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Re: Mcculloch SP81
« Reply #2 on: February 29, 2016, 10:53:56 am »
the only adjustment is the large screw at the top left corner of the picture, where the H and L adjustments normally are  are blocked off with brass plugs.
Logged

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Re: Mcculloch SP81
« Reply #3 on: February 29, 2016, 11:23:31 am »
i see a walbro sdc 65 on ebay that appears to be fully adjustable, it says it is off of a 10-10a, do you think it would be large enough to run on the sp81?
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
8 Replies
489 Views 		Last post January 21, 2012, 09:29:50 am
by man of stihl
13 Replies
1024 Views 		Last post June 14, 2013, 09:00:48 pm
by Al Smith
8 Replies
666 Views 		Last post May 24, 2013, 12:14:28 pm
by HMLT360Pro
11 Replies
1179 Views 		Last post November 16, 2013, 05:12:44 am
by Al Smith
2 Replies
355 Views 		Last post December 10, 2013, 08:12:02 pm
by jmester
5 Replies
1290 Views 		Last post October 04, 2021, 11:55:09 am
by joe_indi
mcculloch 110

Started by Cut4fun . « 1 2 » McCulloch

13 Replies
1069 Views 		Last post May 09, 2015, 12:01:24 pm
by Cut4fun .
3 Replies
170 Views 		Last post July 26, 2014, 10:32:30 am
by Cut4fun .
6 Replies
467 Views 		Last post April 08, 2015, 07:29:35 pm
by Eccentric
4 Replies
440 Views 		Last post July 23, 2015, 04:39:14 pm
by Cut4fun .