« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: PM 605 hard starter?  (Read 1829 times)

0 Members and 0 Guests are viewing this topic.

Offline Rich73Kelly

  • 3 cube
  • *
  • Posts: 15
  • Karma: 1
  • Location: Neenah, WI USA
Re: PM 605 hard starter?
« Reply #20 on: January 29, 2016, 11:51:23 am »
Al, I hear ya on "being fickle" .... I took it all apart last time it bound up ... blew everything out, wiped everything down, including the spring, and put it all back together, only to have it bind up with the cord dangling all the way out again after ten or fifteen pulls. Is there a torque spec for that drum bolt? I tried not going too tight cause it's going into plastic but, I know it's snugged up. As far as lubing it goes, I figured oil would just attract dirt. Could I maybe spray it down with Silicone spray and let it air dry? I am about ready to find a different recoil assembly!
Logged
If we can't fix it, IT ain't broke!
Pages: 1 2 [3]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
7 Replies
1160 Views 		Last post December 30, 2011, 02:49:41 am
by rms61moparman
5 Replies
1040 Views 		Last post December 27, 2011, 01:49:31 pm
by huskyman
16 Replies
978 Views 		Last post February 04, 2013, 07:36:59 pm
by 660magnum
14 Replies
1041 Views 		Last post October 30, 2013, 08:41:27 pm
by president
10 Replies
955 Views 		Last post February 04, 2014, 03:24:19 pm
by president
6 Replies
711 Views 		Last post May 30, 2014, 08:24:23 pm
by Billyram
6 Replies
350 Views 		Last post April 08, 2015, 11:39:15 am
by Randy
9 Replies
410 Views 		Last post October 26, 2015, 08:31:35 pm
by dannyupsolate
16 Replies
3589 Views 		Last post September 06, 2020, 09:55:48 pm
by Spike60
0 Replies
127 Views 		Last post May 10, 2018, 07:00:46 pm
by Eccentric