Author Topic: Pro Mac 610 oil tank repair  (Read 1327 times)

0 Members and 1 Guest are viewing this topic.

Offline fordfairlane78

  • 6 cube
  • ****
  • Posts: 160
  • Karma: 16
  • Location: Valley Center,KS
Re: Pro Mac 610 oil tank repair
« on: May 17, 2014, 05:19:02 am »
I have not removed an oil tank on a pm610 but have done a bearcat? Which I believe is a newer 55cc version of this design so it should be similar.  If it's the same you won't have to split the case but a lot of disassembling is required.  I used permatex gasket maker to reseal the one I did.  If you have been lucky enough to not have the oiler feed line break, which was the problem with this one, definitely replace the line while you have it apart as they are impossible, at least to me, to change while the tank is intact.

Trapped in time, surrounded by evil, low on gas

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
1039 Views
Last post January 10, 2018, 07:47:10 am
by Cut4fun .
6 Replies
736 Views
Last post December 15, 2013, 02:24:45 pm
by Al Smith
6 Replies
887 Views
Last post December 12, 2011, 10:20:07 am
by doggerz
6 Replies
502 Views
Last post December 17, 2012, 05:29:48 pm
by Al Smith
1 Replies
183 Views
Last post June 26, 2013, 08:07:52 pm
by Cut4fun .
3 Replies
165 Views
Last post May 12, 2014, 03:36:02 pm
by winland
7 Replies
123 Views
Last post December 08, 2015, 12:07:28 pm
by Cut4fun .
1 Replies
200 Views
Last post February 25, 2016, 12:17:15 pm
by Cut4fun .
0 Replies
223 Views
Last post November 05, 2016, 05:11:07 pm
by blueflame
4 Replies
167 Views
Last post July 15, 2019, 05:31:03 am
by Al Smith