« previous next »
Pages: 1 [2]   Go Down

Author Topic: A way to fixture pistons..in a lathe  (Read 763 times)

0 Members and 0 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181
Re: A way to fixture pistons..in a lathe
« Reply #10 on: December 11, 2015, 10:19:46 pm »
I'll tell you an idea I had .Machining rings for what ever size piston you are dealing with as far as OD of the piston,48-52 mm  etc .About 3/4" wide maybe 30-40 thou thick .Just make a saw cut, one across it .In theory once it's in a three jaw it should clamp it dead on center . Just a theory .I never did it no more pistons than I work on .
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
634 Views 		Last post August 02, 2011, 03:27:25 pm
by Al Smith
1 Replies
867 Views 		Last post May 09, 2012, 08:32:08 pm
by Al Smith
0 Replies
111 Views 		Last post July 19, 2013, 10:02:28 am
by adam32
1 Replies
262 Views 		Last post August 24, 2014, 08:11:47 pm
by tlandrum
73 Replies
1886 Views 		Last post October 13, 2015, 04:49:52 pm
by EHP
5 Replies
250 Views 		Last post March 05, 2015, 01:46:06 pm
by Cut4fun .
18 Replies
1108 Views 		Last post July 31, 2015, 12:48:53 pm
by SawTroll
6 Replies
446 Views 		Last post November 30, 2015, 04:15:44 pm
by 1manband
51 Replies
2088 Views 		Last post March 12, 2019, 10:18:52 am
by Cut4fun .
5 Replies
352 Views 		Last post May 26, 2021, 03:51:02 pm
by Philbert