« previous next »
Pages: 1 [2] 3 4 5 6   Go Down

Author Topic: Lathe for saw work  (Read 2891 times)

0 Members and 42 Guests are viewing this topic.

Offline mdavlee .

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171

    • Total Badges: 31
    Badges: (View All)
    Level 6 Sixth year Anniversary Fifth year Anniversary 1000 Posts Fourth year Anniversary 500 Posts
Re: Lathe for saw work
« Reply #10 on: February 14, 2017, 06:51:51 pm »
It's not bad with a plate and 4 studs. Just takes forever to get zero runout up and down the bore. Best thing is if you wear out a piston you can put a new one in without machine work
Logged
Pages: 1 [2] 3 4 5 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
837 Views 		Last post August 02, 2011, 03:27:25 pm
by Al Smith
1 Replies
987 Views 		Last post May 09, 2012, 08:32:08 pm
by Al Smith
7 Replies
602 Views 		Last post October 22, 2013, 03:22:11 pm
by tlandrum
6 Replies
911 Views 		Last post February 20, 2014, 07:38:22 pm
by Al Smith
1 Replies
399 Views 		Last post August 24, 2014, 08:11:47 pm
by tlandrum
6 Replies
636 Views 		Last post November 30, 2015, 04:15:44 pm
by 1manband
13 Replies
1200 Views 		Last post December 11, 2015, 10:19:46 pm
by Al Smith
19 Replies
766 Views 		Last post May 01, 2017, 02:07:24 pm
by 3000 FPS
2 Replies
595 Views 		Last post March 31, 2021, 04:48:50 pm
by Cut4fun .
3 Replies
294 Views 		Last post December 14, 2023, 12:29:24 am
by 3000 FPS