« previous next »
Pages: 1 [2] 3 4 5 6   Go Down

Author Topic: Lathe for saw work  (Read 2896 times)

0 Members and 59 Guests are viewing this topic.

Offline EHP

  • Gas Hotsaw
  • ******
  • Posts: 637
  • Karma: 80

    • Total Badges: 32
    Badges: (View All)
    Level 6 Linux User Mobile User Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary
Re: Lathe for saw work
« Reply #10 on: February 16, 2017, 11:03:59 am »
Im abit slow ok but this is what I did , I turned down a piece of alum. in a 3 jaw chuck , spun alum down so the its tight to bore size of jug, , with jug mounted on alum using the bore to be centered I then drilled the 4 holes that once threaded will hold the cylinder to the alum. so if you want to cut the squish band you can, its not perfect but it has you very close to center to start with
Logged
Pages: 1 [2] 3 4 5 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
837 Views 		Last post August 02, 2011, 03:27:25 pm
by Al Smith
1 Replies
987 Views 		Last post May 09, 2012, 08:32:08 pm
by Al Smith
7 Replies
602 Views 		Last post October 22, 2013, 03:22:11 pm
by tlandrum
6 Replies
912 Views 		Last post February 20, 2014, 07:38:22 pm
by Al Smith
1 Replies
399 Views 		Last post August 24, 2014, 08:11:47 pm
by tlandrum
6 Replies
636 Views 		Last post November 30, 2015, 04:15:44 pm
by 1manband
13 Replies
1201 Views 		Last post December 11, 2015, 10:19:46 pm
by Al Smith
19 Replies
767 Views 		Last post May 01, 2017, 02:07:24 pm
by 3000 FPS
2 Replies
595 Views 		Last post March 31, 2021, 04:48:50 pm
by Cut4fun .
3 Replies
294 Views 		Last post December 14, 2023, 12:29:24 am
by 3000 FPS