« previous next »
Pages: 1 2 [3] 4 5 6   Go Down

Author Topic: Lathe for saw work  (Read 2909 times)

0 Members and 108 Guests are viewing this topic.

Offline mdavlee .

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171

    • Total Badges: 31
    Badges: (View All)
    Level 6 Sixth year Anniversary Fifth year Anniversary 1000 Posts Fourth year Anniversary 500 Posts
Re: Lathe for saw work
« Reply #20 on: February 16, 2017, 05:06:26 pm »
Quote from: EHP on February 16, 2017, 11:03:59 am
Im abit slow ok but this is what I did , I turned down a piece of alum. in a 3 jaw chuck , spun alum down so the its tight to bore size of jug, , with jug mounted on alum using the bore to be centered I then drilled the 4 holes that once threaded will hold the cylinder to the alum. so if you want to cut the squish band you can, its not perfect but it has you very close to center to start with
Never thought of doing it that way.
Logged
Pages: 1 2 [3] 4 5 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
842 Views 		Last post August 02, 2011, 03:27:25 pm
by Al Smith
1 Replies
988 Views 		Last post May 09, 2012, 08:32:08 pm
by Al Smith
7 Replies
605 Views 		Last post October 22, 2013, 03:22:11 pm
by tlandrum
6 Replies
917 Views 		Last post February 20, 2014, 07:38:22 pm
by Al Smith
1 Replies
401 Views 		Last post August 24, 2014, 08:11:47 pm
by tlandrum
6 Replies
637 Views 		Last post November 30, 2015, 04:15:44 pm
by 1manband
13 Replies
1205 Views 		Last post December 11, 2015, 10:19:46 pm
by Al Smith
19 Replies
773 Views 		Last post May 01, 2017, 02:07:24 pm
by 3000 FPS
2 Replies
597 Views 		Last post March 31, 2021, 04:48:50 pm
by Cut4fun .
3 Replies
295 Views 		Last post December 14, 2023, 12:29:24 am
by 3000 FPS