« previous next »
Pages: [1]   Go Down

Author Topic: 2 old Craftsman  (Read 806 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22183
  • Karma: 560
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
2 old Craftsman
« on: June 29, 2014, 01:28:40 pm »
Any idea on models?
Logged
REDNECK Saw Repair Getter Done

Share on Facebook Share on Twitter

Offline super44

  • 6 cube
  • ****
  • Posts: 214
  • Karma: 8
  • I have a really big Johnson.
  • Location: NW Wis
Re: 2 old Craftsman
« Reply #1 on: July 01, 2014, 09:32:22 pm »
Logged

Offline 67L36Driver

  • 5 cube
  • ***
  • Posts: 111
  • Karma: 23
Re: 2 old Craftsman
« Reply #2 on: November 13, 2014, 07:27:07 am »
David Bradley's?
Logged

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: 2 old Craftsman
« Reply #3 on: July 13, 2015, 12:41:04 am »
Logged
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1202 Views 		Last post July 18, 2012, 01:40:02 pm
by Cut4fun .
105 Replies
2398 Views 		Last post January 07, 2021, 08:33:40 am
by Cut4fun .
6 Replies
368 Views 		Last post October 16, 2013, 03:40:39 pm
by KilliansRedLeo
3 Replies
218 Views 		Last post November 13, 2013, 10:53:09 pm
by jcsmith
11 Replies
849 Views 		Last post August 23, 2016, 02:32:39 am
by Eccentric
5 Replies
248 Views 		Last post February 11, 2014, 03:36:38 pm
by Cut4fun
15 Replies
1334 Views 		Last post April 03, 2014, 09:01:13 am
by KilliansRedLeo
9 Replies
379 Views 		Last post July 11, 2014, 05:46:51 pm
by Eccentric
7 Replies
237 Views 		Last post July 15, 2014, 10:27:39 pm
by Tractorsaw1
2 Replies
386 Views 		Last post September 23, 2014, 07:29:34 pm
by Cut4fun .