« previous next »
Pages: [1]   Go Down

Author Topic: Echo  (Read 545 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21886
  • Karma: 522
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Echo
« on: June 12, 2014, 02:46:46 pm »
What model?
Logged
REDNECK Saw Repair Getter Done

Share on Facebook Share on Twitter

Offline man of stihl

  • Nitro Hotsaw
  • *******
  • Posts: 1219
  • Karma: 71
  • NW PA
  • Location: nw pennsylvania
Re: Echo
« Reply #1 on: June 12, 2014, 06:45:15 pm »
CS-302?
Logged
Ron

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Echo
« Reply #2 on: July 13, 2015, 12:45:42 am »
Quote from: man of stihl on June 12, 2014, 06:45:15 pm
CS-302?

Looks like it.  A CS302S would have an op-pres lever.
Logged
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
2 Replies
566 Views 		Last post February 06, 2012, 08:39:26 pm
by DB_43725
1 Replies
276 Views 		Last post October 27, 2012, 10:27:31 pm
by Al Smith
8 Replies
354 Views 		Last post September 28, 2013, 03:47:02 pm
by Cut4fun .
Echo 290

Started by Cut4fun . Echo

1 Replies
274 Views 		Last post September 19, 2013, 05:24:50 pm
by sharkey
3 Replies
266 Views 		Last post December 12, 2014, 12:12:03 am
by Eccentric
2 Replies
218 Views 		Last post September 21, 2014, 11:37:30 pm
by 660magnum
7 Replies
289 Views 		Last post October 06, 2014, 09:32:58 am
by rusted bolts
0 Replies
165 Views 		Last post October 31, 2014, 02:38:07 pm
by leec
Echo 340 T

Started by Cut4fun . « 1 2 3 » Echo

27 Replies
1203 Views 		Last post January 29, 2016, 09:06:32 pm
by Cut4fun .
9 Replies
889 Views 		Last post November 04, 2017, 08:43:38 pm
by Jaymo