Author Topic: 2 old Craftsman  (Read 594 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 17719
  • Karma: 333
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
2 old Craftsman
« on: June 29, 2014, 01:28:40 pm »
Any idea on models?
REDNECK Saw Repair Getter Done

Social Buttons


Offline super44

  • 6 cube
  • ****
  • Posts: 207
  • Karma: 7
  • I have a really big Johnson.
  • Location: NW Wis

Online 67L36Driver

  • 5 cube
  • ***
  • Posts: 111
  • Karma: 23
Re: 2 old Craftsman
« Reply #2 on: November 13, 2014, 07:27:07 am »
David Bradley's?

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2032
  • Karma: 197
  • Magnesium and Iron.
  • Location: Northern California.
Re: 2 old Craftsman
« Reply #3 on: July 13, 2015, 12:41:04 am »
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
54 Replies
2020 Views
Last post July 20, 2016, 06:31:43 pm
by Cut4fun .
2 Replies
979 Views
Last post July 18, 2012, 01:40:02 pm
by Cut4fun .
86 Replies
1227 Views
Last post December 01, 2015, 07:27:05 pm
by The Ripper
6 Replies
255 Views
Last post October 16, 2013, 03:40:39 pm
by KilliansRedLeo
3 Replies
173 Views
Last post November 13, 2013, 10:53:09 pm
by jcsmith
11 Replies
477 Views
Last post August 23, 2016, 02:32:39 am
by Eccentric
5 Replies
172 Views
Last post February 11, 2014, 03:36:38 pm
by Cut4fun
15 Replies
1088 Views
Last post April 03, 2014, 09:01:13 am
by KilliansRedLeo
9 Replies
295 Views
Last post July 11, 2014, 05:46:51 pm
by Eccentric
2 Replies
346 Views
Last post September 23, 2014, 07:29:34 pm
by Cut4fun .