Author Topic: 2 old Craftsman  (Read 782 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: 2 old Craftsman
« on: July 13, 2015, 12:41:04 am »
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1178 Views
Last post July 18, 2012, 01:40:02 pm
by Cut4fun .
104 Replies
2335 Views
Last post June 05, 2019, 10:51:03 am
by Cut4fun .
6 Replies
358 Views
Last post October 16, 2013, 03:40:39 pm
by KilliansRedLeo
3 Replies
216 Views
Last post November 13, 2013, 10:53:09 pm
by jcsmith
11 Replies
807 Views
Last post August 23, 2016, 02:32:39 am
by Eccentric
5 Replies
243 Views
Last post February 11, 2014, 03:36:38 pm
by Cut4fun
15 Replies
1324 Views
Last post April 03, 2014, 09:01:13 am
by KilliansRedLeo
9 Replies
366 Views
Last post July 11, 2014, 05:46:51 pm
by Eccentric
7 Replies
234 Views
Last post July 15, 2014, 10:27:39 pm
by Tractorsaw1
2 Replies
385 Views
Last post September 23, 2014, 07:29:34 pm
by Cut4fun .