Author Topic: It's yellow but what is it?  (Read 1387 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: It's yellow but what is it?
« Reply #10 on: September 10, 2015, 02:51:58 pm »
There has been a commercially available R/C version of the little Quadra engine available since about 1980 or so.  That was one of the first OPE based large scale engines on the market.  As the large scale market has grown, the list of gas engine mfgs has grown with it.  OPE based and purpose built large scale and giant scale engines abound.  There's also many folks out there (and here on this board) that covert various OPE engines for RC use.

Fixed the minor issue by changing four letters.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
21 Replies
2746 Views
Last post March 12, 2016, 05:14:26 am
by Al Smith
8 Replies
2087 Views
Last post August 15, 2012, 01:51:39 pm
by Cut4fun .