« previous next »
Pages: [1] 2   Go Down

Author Topic: Partner 540 partner 5500  (Read 2987 times)

0 Members and 0 Guests are viewing this topic.

Offline Magnus

  • 6 cube
  • ****
  • Posts: 237
  • Karma: 26
  • Location: Sweden
    • Chainsaw Collectors Forum
Re: Partner 540 partner 5500
« on: February 08, 2014, 04:27:09 am »
I don't think I have seen a open port on a 5500/540 yet.
All piston ported/closed port. But they have cuts in case for open ports, but not in gasket and cylinder.

First 5000 and 500 was open ports. Last 500 was piston ported as well as 5000.

A bit confusing about the cuts in case for transfers...

Logged
Chainsaw nut!
Pages: [1] 2   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
46 Replies
5569 Views 		Last post November 05, 2021, 06:43:18 pm
by partner
partner 500

Started by man of stihl « 1 2 » Partner

18 Replies
1900 Views 		Last post July 06, 2015, 05:35:27 pm
by aclarke
8 Replies
1425 Views 		Last post April 25, 2011, 08:32:59 pm
by Cut4fun
6 Replies
530 Views 		Last post December 17, 2011, 04:24:09 pm
by brokenbudget
8 Replies
1708 Views 		Last post April 27, 2012, 10:48:06 am
by SawTroll
0 Replies
904 Views 		Last post April 13, 2012, 01:45:51 pm
by man of stihl
1 Replies
213 Views 		Last post April 17, 2012, 07:02:05 am
by Cut4fun .
0 Replies
110 Views 		Last post May 15, 2013, 02:05:50 pm
by Cut4fun .
7 Replies
976 Views 		Last post June 09, 2013, 08:34:40 am
by HMLT360Pro
7 Replies
937 Views 		Last post June 04, 2018, 02:01:44 pm
by Cut4fun .