Chainsaw Repair

Old thread but after all this time and now retired nearly two years I've finally started the rebuild on two. Mac 1000 /Partner P100's One will be in McCulloch trim the other Partner .I've got all the parts I think unless one coil is bad which I don't know plus  the seals .Partner IPL's are most screwed up I've ever seen .I found an IPL in English   thank goodness and cross referenced the seals with CR .
One was stuck tighter than a bulls butt at fly time,I had to pop it loose with a grease gun .The cylinder looks nearly  new and rings are stuck which might take a torch to pop them loose .It's in a bucket full of kerosene at the moment
The first will be a good lower end I found with the cylinder and piston from the one that stuck one .The one I have running will be the crankcase of the stuck one with good parts from the runner plus new rings and seals of course .The runner is a dog,I can out run it with a souped up Stihl 038 Magnum .Something wrong with that 72 cc up against 99 cc. I do fairly well with modifications but not that good .