Author Topic: p 41 flywheel  (Read 1007 times)

0 Members and 0 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: p 41 flywheel
« Reply #10 on: June 05, 2014, 12:42:22 pm »
OK Bob, here you go!

The first two pictures are of the piston circlip installed in the piston correctly, the second picture clearly shows the groove in the piston pin boss where the circlip goes.
The third picture is the piston ring installed correctly

If you click on the pictures they will enlarge so that you can see them clearly.

KRL
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
6 Replies
545 Views
Last post October 14, 2012, 02:20:05 pm
by Jim372xp
3 Replies
291 Views
Last post January 17, 2013, 07:33:10 pm
by jmester
18 Replies
830 Views
Last post October 27, 2013, 09:26:23 pm
by 660magnum
50 Replies
2578 Views
Last post March 16, 2015, 12:16:53 pm
by Cut4fun .
31 Replies
452 Views
Last post November 25, 2014, 07:12:07 am
by Al Smith
23 Replies
899 Views
Last post November 04, 2014, 03:13:07 pm
by bloodontheice
15 Replies
332 Views
Last post December 05, 2014, 01:30:49 pm
by aclarke
5 Replies
124 Views
Last post January 13, 2015, 08:11:11 pm
by man of stihl
6 Replies
337 Views
Last post January 02, 2016, 11:17:33 am
by Al Smith
5 Replies
149 Views
Last post July 20, 2016, 07:33:47 pm
by 1manband